Spring Hanger (25 mm)that we offer is available with 25mm standard deflection. Our Spring Hanger is extensively used for isolation of vibration produced by suspended mechanical equipment, low speed suspended fan, transformers, ductwork, piping, etc. It is especially recommended for isolating any suspended source of audible or inaudiable noise and vibration with minimum static deflection requirement exceeding 13 mm and up to 25 mm. We make available bulk quantities of our Spring Hanger at very economical rates.
Conforms To
- Designed to BS 1726-1: 1987.
- Tolerance to BS 1726-1: 2002.
- SAE and Ashrae Guidelines for vibration isolation
Features
- Spring diameter to height ratios are designed to ensure that spring will never buckle even when fully loaded.
- Suspension rod misalignment (30 degree arc) is compensated in hanger design.
- Locking rubber bush centralizes the spring and prevents dislocation.
- Springs are powder coated with appropriate color coding to facilitate identification.
- Frame is made of G.I. Steel and powder coated to 100 microns paint thickness (exceeds 1000 hours of salt spray test) and conforming to ASTM B-117.
- Option : Frame Hot dip Galvanized. Part Number prefix with "HDG"
- Spring Neoprene coated. Part Number Prefix with "N"
- Spring Plastic Dip coated. Part Number prefix with "P".
- Isolation Brackets are capable of overloading upto 500%.
Selection / Ordering
- Point load (Calculated to include all variables such as weight of water in pipe lines etc. If applicable).
Installation Guide Lines
